Godox Cube-SC Kit2 2.4 GHz Wireless Microphone with 2 Transmitters and USB-C Receiver for Smartphone Tablet and Computer

Demo unit – checked and ready to ship. Condition: New.

Shooting reels, interviews or livestreams on your phone, and the built-in mic sounds like a train station from two metres away? The Godox Cube-SC Kit2 combines two 7 g transmitters with a USB-C receiver that plugs straight into your phone – all carried in a lipstick-sized charging case.

• 2 transmitters + 1 plug-in USB-C receiver, 2.4 GHz, up to 300 m (line of sight)
• Transmitters weigh just 7 g, 75 dB SNR, max. 115 dB SPL
• Approx. 10 h per charge, approx. 30 h with the charging case
• Double-click remote for record/snap and one-press noise reduction

Plug in, clip on, record

No cables, no fiddling

Plug the Cube-SC RX into the USB-C port of your phone, tablet or computer, clip on the transmitters with a magnet or clip, and you're ready for clean audio on social clips, interviews or livestreams.

Control without walking back to the phone

Double-click a transmitter to start recording or snap a photo on your phone – from up to 50 m away. Noise reduction is also one press away on the transmitter.

Fine-tune in the app

The Godox Mic app gives you real-time monitoring, volume, dual-mode noise reduction, speaker playback and firmware updates.

What it looks like in practice

Two-person interview for social media

Plug the receiver into your phone, give each person a transmitter and double-click to start recording. Afterwards, everything goes back into the case to charge for the next job.

Good to know before you order

USB-C devices only

The receiver has only a USB-C plug – no 3.5 mm output – so it won't work with cameras that lack USB audio. For Lightning iPhones, there's the Cube-SL version.

Cases and rigs

Depending on your phone case or rig, the plug-in receiver may be blocked – check that the USB-C port is freely accessible.

About 10 hours per transmitter

The 30-hour total requires recharging in the case (roughly two full charges for two transmitters).

Technical details at a glance

• Transmission: 2.4 GHz frequency hopping, up to 300 m (line of sight)
• Cube-S TX transmitter: omni, 20 Hz – 20 kHz, max. 115 dB SPL, 86 dB dynamic range, 75 dB SNR
• Sample rate: 48 kHz / 24-bit
• Transmitter: 3.87 V / 97 mAh, approx. 10 h, approx. 1.5 h charge, approx. 7 g
• Cube-SC RX receiver: USB-C plug, powered by host device, 75 dB SNR, approx. 5 g
• Charging case: 3.8 V / 850 mAh, charges 2 devices about twice, approx. 2 h charge, approx. 49 g
• App: Godox Mic
• Operating temperature: -10 °C to +50 °C

In the box

• 2 x Cube-S TX transmitters
• 1 x Cube-SC RX receiver (USB-C)
• 1 x charging case
• 2 x magnetic clips
• 4 x magnets
• 2 x furry windscreens
• 2 x lanyards
• 1 x USB-A to USB-C data cable
• 12 x transmitter stickers
• 1 x pin
• 1 x storage case