Screen protectors for your camera
After the sensor, the rear screen is the most vulnerable part of your camera. A zip, the edge of a table or sand in a jacket pocket is all it takes for the first scratch. A tempered glass screen protector takes the hit before it gets expensive. Here you'll find precisely cut protectors from GGS Larmor and JJC for over 80 models from Canon, Sony, Nikon, Fujifilm, Leica, Ricoh, Panasonic, Hasselblad and other brands. Use the «My camera» filter to see straight away what fits your model.
Why glass instead of film?
A classic protective film is thin and soft. It scratches itself, tends to trap bubbles and does little against knocks. A real glass protector is tempered, around 0.3 to 0.5 mm thick depending on the model, and far more durable. Scratches and impacts land on the glass instead of the screen. And if something does break, you replace the glass for a few francs rather than the screen for several hundred.
Clear view and full touch control
The protectors are made of optical glass with over 90 percent light transmission. Colour, sharpness and brightness on the screen are preserved, so you can still judge exposure and focus reliably. Many models have an anti-fingerprint and anti-reflective coating, which helps especially outdoors in bright sun. Because the glass sits directly on the screen, the touchscreen works as usual, including focus point selection, menus and playback.
No adhesive needed
The protector holds by adhesion, with no glue at all. Clean the screen thoroughly, remove any dust, line up the glass and tap it briefly in the middle. It settles into place by itself and can later be removed without residue. Tip: fit it in a low-dust room, for example the bathroom after a shower, and hardly any dust will get trapped underneath.
Finding the right screen protector
Each protector is cut to the screen size and shape of a specific camera model, so check the model name carefully. One glass often fits several cameras with the same screen, such as the Sony A7 IV, A7C II and A6700, or the Nikon Z8, Z9 and Zf. Compatible models are listed in each product description.
Cameras we have screen protectors for
- Canon: EOS R1, R5 Mark II, R5, R6 Mark III, R6 Mark II, R6, R7, R8, R10, R50, R100, PowerShot V10 and DSLRs such as the 5D Mark IV, 6D, 7D Mark II and 90D
- Sony: Alpha 7R V, 7 IV, 7C II, 7CR, 9 III, A6700, A6600, A6400, ZV-1 II, ZV-E1, FX3, FX30 and RX100
- Nikon: Z9, Z8, Zf, Zfc, Z6 III, Z5 II, Z50 II, ZR and D850, D780, D7500, D5 and D6
- Fujifilm: X100VI, X100V, X-T5, X-T30 II, X-S20, X-H2S, X-E5, X-M5, X-Pro2, GFX100 II and GFX100RF
- Others: Leica Q3, Ricoh GR IV and GR III/IIIx, Hasselblad X2D II 100C, Panasonic GH5 and LX100, Olympus OM-D E-M10 Mark II, Kodak Pixpro and Insta360
Good to know
Tilting and vari-angle screens
On cameras with a tilting or vari-angle screen, the screen often won't close completely flush when folded inwards with a protector fitted. Facing outwards, everything works normally, and since the glass already protects the screen, folding it in for protection is no longer necessary.
Already a scratch on the screen?
A glass protector usually hides fine scratches well, because the glass bridges the gap. Deep scratches or cracks remain visible. On strongly curved screens or rounded edges, the glass may lift very slightly at the border.
More protection for your gear
For shooting in bright sun, a screen loupe or sun hood is also worth having. More products against rain, dust and scratches are in Protection and care.
























